EVMDM365 Test Case Status

Additional tests will be added soon.

Test Name Description Status Notes
ADC Converts the fixed voltages at each ADC input to a digital value. PASS Place jumper in TP16 only after board is powered
AIC3101 Tests all the audio signals PASS Sends a tone out of Headphoneout and Lineout and then loops back audio from Linein and Micin
CPLD Reads and writes to CPLD registers PASS .
CPLD_Power This test is used to selectively turn on or off power domains controlled by the CPLD PASS .
DDR Reads/writes to the DDR PASS .
EEPROM Reads/writes to the I2C EEPROM PASS .
EMAC loopback Loops data through an external loopback connector PASS Requires external loopback connector
msp430-ir This test retrieves the IR data from the MSP430 PASS Press power button to end test
nand flash lower Reads/writes to NAND Flash PASS .
nand flash upper Reads/writes to NAND Flash PASS .
onenand Reads/writes to OneNAND PASS Requires switch 1 on SW5 to be set in the 'ON' position
RTC Starts and checks the Real Time Clock Calendar PASS RTC must be in right mode for test to work
sd0 Reads/writes to SD card PASS .
sd1 Reads/writes to SD card PASS .
setmac Sets MAC address PASS .
SPIROM Reads/writes to SPIROM PASS .
switchTests the Keyscan module associated with the switch buttons on the board PASS Must press all buttons from SW6 to SW21 to pass.
UART Loopback through UART Port PASS Requires external loopback connector
usb_power Tests USB power PASS Check and see if Pin 4 of U4 is alternating to the high and low state
video_colorbars_hd-720P Outputs HD colorbars PASS .
video_colorbars_sd Outputs standard definition colorbars PASS .
video_loopback_hd-720P Loops HD Video PASS Use 720P Source
video_loopback_sd Loops standard definition Video PASS .
voicecodec Outputs tone on onboard speaker PASS Place jumpers on TP22 and TP29
wdtdisable Disables the Watchdog timer PASS .



©Copyright 2002-2008 Spectrum Digital, Inc. All Rights Reserved.