Davinci HD FAQ (Beta)
Hardware Topics
Code Composer Setup / Driver Support (07/19/07)
The supported debug target for DaVinci HD is Code Composer 3.3. If you are using
Spectrum Digital JTAG emulators, you can get DaVinci HD EVM CCSetup configurations
and drivers tested against the DaVinci HD silicon by installing the latest version of
our emulation driver packages at:
http://support.spectrumdigital.com/ccs33 (Spectrum Digital XDS510 Series Emulators)
http://support.spectrumdigital.com/ccs3x_xds560r (Spectrum Digital XDS560R Series Emulators)
Configuration Switch Settings (06/27/07)
Here is the configuration for SW3 on the DaVinci HD board.
SW3:
[OFF=0][ON=1]
/----------\
| # OFF ON | [OFF=0] [ON=1]
BM0 -| 1 X |-- *BM[0]=0 BM[0]=1
BM1 -| 2 X |-- *BM[1]=0 BM[1]=1
BM2 -| 3 X |-- *BM[2]=0 BM[2]=1
BM3 -| 4 X |-- *BM[3]=0 BM[3]=1
BW -| 5 X |-- *8-bit bus 16-bit bus
PCI -| 6 X |-- *PCI-OFF PCI-ON
DSP -| 7 X |-- *DSP-OFF(Reset) DSP-ON
SR -| 8 X |-- *SmartReflex-Off SmartReflex-On
\----------/
SW3
Boot Modes:
(BM[3:0]) (BM[3:0])
(when PCI-OFF) (when PCI-ON)
-------------------------------------------
*0000:EMU
0010:HPI-16 0010:PCI w/o auto init
0011:HPI-32 0011:PCI w/ auto init
0100:EMIFA
0110:I2C
0111:NAND
1000:UART0
1001:Emulation
1010:VLYNQ
1011:EMAC
1110:SPI
ELSE:N/A
PCI Configuration Switch Settings (07/11/07)
Here is the PCI configuration for SW3 on the DaVinci HD board.
For PCI w/ auto init:
/----------\
| # OFF ON |
BM0 -| 1 X |-- BM[0]
BM1 -| 2 X |-- BM[1]
BM2 -| 3 X |-- BM[2]
BM3 -| 4 X |-- BM[3]
BW -| 5 X |-- 8-bit BusWidth
PCI -| 6 X |-- PCI Enable
DSP -| 7 X |-- DSP Off
SR -| 8 X |-- SmartReflex Off
\----------/
SW3
For PCI w/o auto init:
/----------\
| # OFF ON |
BM0 -| 1 X |-- BM[0]
BM1 -| 2 X |-- BM[1]
BM2 -| 3 X |-- BM[2]
BM3 -| 4 X |-- BM[3]
BW -| 5 X |-- 8-bit BusWidth
PCI -| 6 X |-- PCI Enable
DSP -| 7 X |-- DSP Off
SR -| 8 X |-- SmartReflex Off
\----------/
SW3
| 
