Site Index
   Support Home
   C2000 Products
   C5000 Products
   C6000 Products
   OMAP Products
   JTAG Emulators/
Emulation Drivers
   Legacy Support
   Ordering Info.

Manual CCStudio v3.1 Configuration

Overview
This page is a guide to installing the Spectrum Digital XDS510 USB JTAG emulator -or- XDS510 PP+ JTAG emulator for use with Code Composer Studio version 3.1 ( CCStudio v3.1 ). These instructions assume that you have already installed CCStudio in the default directory of:

   C:\CCStudio_v3.1
If you have chosen to install CCStudio in a different location you must manually adjust each step below to match your actual install path.

Choosing to manually configure CCStudio v3.1 is recommended only for non Spectrum Digital development board using a Spectrum Digital JTAG emulator. Manual configuration requires a more in-depth knowledge of your JTAG emulator and of your development board. Each JTAG emulator has a unique I/O port address. Each development board has a unique JTAG scan chain setup composed of the individual processors. This information is feed into CCStudio Setup and is the only way CCStudio can determine what it should connect to.


Manual CCStudio v3.1 Configuration

Configure CCStudio

To illustrate how to manually configure CCStudio v3.1, you will be guided on how to configure CCStudio for a Spectrum Digital XDS510 USB JTAG emulator connected to an EVM5509.

  1. Launch the desktop icon [Setup CCStudio v3.1]

  2. Press the Remove All button to clean up the System Configuration pane.

  3. In the Create Board tab double click on the "SD510USB Emulator" option.



    Available Connections Option Spectrum Digital JTAG emulator
    SD510 Emulator XDS510 PP+ JTAG emulator
    SD510USB Emulator XDS510 USB JTAG emulator
    SDDSKUSB Emulator Embedded DSK JTAG emulator

  4. In the new Connection Properites window enter a name for this setup, "USB Emulator", then press Next.



  5. Now select the Emulator I/O port, "USB Emulator address is 0x510", then press Finish.



  6. Now choose, from Available Processors double click on "TMS320C5500".



  7. Each individual processor needs a Processor Name, use the "TMS320C5500_0", then browse for the GEL File located at "C:\CCStudio_v3.1\boards\evm5509\gel\sd5509evm.gel", then press OK.



  8. Save the settings ( File --> Save )

  9. Exit out of CCStudio Setup and start CCStudio v3.1.


Guides and References

There are three useful guides if you come across an error during a step from above:

  • Troubleshooting guide - For problems involving your JTAG emulator, development board, TI CCStudio, and your CCStudio projects.

  • Software guide - For general information about the JTAG emulator utilities and setup. For general information involving CCStudio versions, setup configuration, components, and debug environment.

  • Hardware guide - For general information about the JTAG emulator hardware, daughtercards, general tips for hardware developers, and general tips on hardware features.

©Copyright 2002-2014 Spectrum Digital, Inc. All Rights Reserved.
x